Ssh can be enabled on ESXi 5. This has the added benefit you can also manage the raid using the tw_cli tool through an ssh session. You will have to repeat this after the ESXi server reboots. Make sure to copy your ssh key so you don't need to provide your password. You can make things work by acquiring a hardware RAID controller from the VMWare Hardware Compatibility List, though. In VMware, run the esxcli software vib install -v/temp/vmware-xxx-sas3ircu. The M1015 is a LSI 9240-8i without the raid 5 options (a feature key adds them) and it can be flashed with various firmware to revert it to a LSI 9211-8i or LSI-9240-8i (with missing raid 5). You can enhance it with grep and whatever else works to only email you in case of an alarm. Fakeraid solutions aren't in the scope of VMWare ESXi blessed setup. Using this raid controller in combination with ESXi 5. Update on ESXi 5.1: the problem was resolved by VMware with the ESXi 5.1 Update 3 (). ![]() Ssh /vmfs/volumes/datastore1/3ware/tw_cli /c0 show alarmsĪnd have the result emailed to you. VMware ESXi 5.1 and 5.5 show the status information UNCONFIGURED GOOD for configured drives of LSI RAID Controllers on the Health Status page. ![]() It looks like the only way to monitor this 3ware raid controller through ESXi is to enable ssh access on the ESXi server, install tw_cli on the datastore (not in places such as /opt because it won't survive a reboot) and set up a daily or weekly cron job to run something like: ssh /vmfs/volumes/datastore1/3ware/tw_cli /c0 show all Intel Corporation Ethernet Controller E810-XXV for backplaneNetwork ESXi 7.0 U3,ESXi 7.0 U2,ESXi 7.0 U1,ESXi 7.0 Intel Corporation Ethernet Controller E810-XXV for QSFP Network ESXi 7.0 U3,ESXi 7.0 U2,ESXi 7.0 U1,ESXi 7.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |